Thanks for help all DK members ...
Hi all,
If anyone can, please help me.
A friend of mine bought a programmer and Cypress processor (CY7C64613) damaged in the usb panel.
He sent it to me for service.
After which I changed constantly I get this error:
Firstly i connected to LPT port=>
L0020: >> 12.12.2015, 22:02:17
L0021: Scanning port(s) for BeeProg .................... found at port LPT1 (378h).
L0022: Establishing connection ... failed. (EC:0805/DE:00000000)
L0023: Programmer cannot be accessed.
Secondly I connected to USB port=>
L0020: >> 12.12.2015, 22:03:58
L0021: Scanning port(s) for BeeProg .................... found at port USB.
L0022: Establishing connection ... failed. (EC:0805/DE:FFFFFFFF/SN:xxx-xxxxx)
L0023: Programmer cannot be accessed.
This is done in software v3.13.
I erased my serial number, sorry !!!
I tested an older software (v2.67 or v2.69), the error code is: EC21.
All of EEPROM content, and the pic content are goods.
In addition to the LM431 IC - 8pin is a 3K resistor and a resistance 100ohmos which was connected in series.
I soldered out of 100 ohms, and then it was an error code.
Despite solder back to the same error.
Regards, G
Thanks for help all DK members ...
try technical support on www.elnec.com
gopelhu (26th March, 2016)
Hi all,
Hehe , I solved the connection error
but I had only one error: Device doesn't have expected number of pins!
This is TTL pindriver error.
Somebody help me with this error?
Regards, G
Last edited by gopelhu; 26th March, 2016 at 03:37 PM.
please i have same problem can you help me ?
I had only one error: Device doesn't have expected number of pins!
Last edited by semsem; 24th June, 2022 at 08:09 PM.
Any one can help me please
Any help please
Any help please
i still cant find solution
Bookmarks