rideon (26th November, 2018)
I found one bad resistor , can you please test and tell me value, Its R15 near USB power diode. and also value on it, but not understand what is exactly... maybe small value used as fuse because comes in serie with VCC to Ics and USB +5v
I found other 01X on board, its 10 Ohms
Last edited by ziko; 26th November, 2018 at 02:03 PM.
rideon (26th November, 2018)
LT1931 switches at 1.2 or 2.2 MHz ,nothing fancy there,no need for a 'proper' scope
01X is indeed 10 ohms +-1%
Now allow me to a smartass and complain about your soldering temperature(too high) and total lack of flux...
That looks like something i would do (or done already)
A failure will not appear till a unit has passed final inspection
I soldered wires there to test And use flux paste Amtech NC559
Very thanks for your help, especially for HEX for mcu
rideon (26th November, 2018)
Received LT1931 yesterday,now scope fully functional. Thanks again to all that helped.
rideon (24th December, 2018)
And my Hantek 1008 broke. On the minus of the case turned out to be a plus. The controller is damaged. On the controller's pinning bus, the resistance is 23 ohms. We need to look for a closure.
I can't download the dump. Help please.
Strange,I didn't find info how I wrote mcu. As I remember I used segger jtag but not know other things
I guess connector is 1:1 all pins
Last edited by ziko; 19th October, 2023 at 04:10 PM.
No words can express my gratitude , i could repair my scope with your file
Thank you very much
Bookmarks