Xprog-M 5.60

**ledong** · 25th May, 2016, 08:44 AM

Xprog -M clone update to 5.60. I uploaded for everyone test it.

https://mega.nz/#!ohkUBByJ!S3zLUWMek...D-5SZzWoZ-2C9U

**cinici** · 25th May, 2016, 09:28 AM

atmega 64 file?

**H2Deetoo** · 25th May, 2016, 10:18 AM

Thank you for the files.
I have XProg v5.55, can I just run this software? Or do I need to upgrade my XPROG hardware as well ?

Regards,
H2Deetoo

**hoangtu** · 25th May, 2016, 01:24 PM

Originally Posted by cinici

atmega 64 file?

sofrware only M8!

**janake** · 26th May, 2016, 09:53 AM

Originally Posted by ledong

Xprog -M clone update to 5.60. I uploaded for everyone test it.

are you test a good job?

**filutek** · 26th May, 2016, 11:49 AM

Not work without upgrade new file atmega

**hoangtu** · 26th May, 2016, 12:03 PM

Originally Posted by filutek

Not work without upgrade new file atmega

you are all right!

**H2Deetoo** · 26th May, 2016, 02:12 PM

Is this ATMega firmware available?

**ucokseparoh** · 26th May, 2016, 02:32 PM

Hi guys.. can anyone here give me a hint please..

IJust bought a Tango and currently is looking for a cheap eeprom reader which is reliable,mostly what i'm after is for Toyota and Honda..preferably the one which is easy to use (as i'm new to this) and supports in-circuit as i don't own yet any soldering kit. I've seen some fellows here said that X-Prog M/UPA/CarProg is good,just a bit confuse to choose one which is fit for my job as a locksmith. Does the one sold by Chinese sellers really work? Any of you guys can recommend me which one should i get? and where best to buy?

Thanks for any help.

Regards..

**amigokola** · 27th May, 2016, 05:48 PM

Originally Posted by ucokseparoh

Hi guys.. can anyone here give me a hint please..

IJust bought a Tango and currently is looking for a cheap eeprom reader which is reliable,mostly what i'm after is for Toyota and Honda..preferably the one which is easy to use (as i'm new to this) and supports in-circuit as i don't own yet any soldering kit. I've seen some fellows here said that X-Prog M/UPA/CarProg is good,just a bit confuse to choose one which is fit for my job as a locksmith. Does the one sold by Chinese sellers really work? Any of you guys can recommend me which one should i get? and where best to buy?

Thanks for any help.

Regards..

For a start UPA will be good but when you will dig further you must have orange5 or xprog .