Help for 2018 Ford Focus 3 Visteon Dash error on display after change odo with Iprog+

[motocarlos]

Hello all,

i need some help for a dash 2018 Ford Focus 3

After try to change ODO with Iprog+ read ok but then after write error is on display, can someone help with some correction for my file or another good dump file.

Site code: FKKNA
Assembly line: 01
Date: 19/12/17
HW: F1ET-14F094-BB
SW: F1ET-14C026-BBQ
VISTEON P/N: VPFMGF-10849-BJJ

F1ET-10849-BJS S/N: 35674381

I need 210000km on it, please.

[perukeyservice]

your mcu is...DT56 and the km orig was 264192 or what is the km original?

[motocarlos]

your mcu is...DT56 and the km orig was 264192 or what is the km original?

Hello,

the MCU is : D70F3425GJ(A) 1742ENCOH

The original km i think is those 264192, i dont remenber now.

Thank you for the help.

Regards.

[motocarlos]

your mcu is...DT56 and the km orig was 264192 or what is the km original?

Hello again,

i found a file with 76000km, with some hardware change, i write it to the dash, and now appears the 76000km on the dash and all work good i think.

I have change with Iprog+ to 210000km as i need , i will write it too.

Do you think i can use this file??

I post them here too.

Please, take a look and please tell me i if i can use it.

Regards.

[perukeyservice]

write the file of 210k if all is ok not problem if there is some problem re-write the file 76k it is working ok

[motocarlos]

Only to know,

Both files worked good.

Regards.

[perukeyservice]

that is good