daxxer (30th August, 2016)
HU56R cutting is bad. HU56R key thickness is 3.5mm. Silca, JMA, Errebi keys thickness are 3.5 mm. Please check it.
haiz0708 (10th September, 2016)
Someone is using this machine in the van? Is good heavy duty? Thanks
Sent from my SM-G925F using Tapatalk
hello samic i have a mini condor...im having a big problem for cutting keys for mercedes hu64 blade
it always cuts wrong..
i have tried also cut bitting still no luck
on diagram it shows place blade on m2 and close to line but, as you know the keys are narrow it can never align close to line always push itself back
i have tired cutting several hu64 no luck at all
rest is fine so far
only hu64 mercedes
please advice what to do,
if there is a special type of adapter needed let me know....
purdy (4th September, 2016)
100% hu64 is ok with condor xc007 and condor mini tested by me many times...
daxxer (3rd September, 2016)
Hi there
Recently got the Condor Mini.
Seems good. However if the dust cover could have been designed a bit away from key it would've been nice. Currently the problem is most keys will touch on dust cover when cutting. Some key like VW Flip key cannot let the cover be closed. So if cover is open then what is the purpose of dust cover because dirt goes everywhere.
hello sir please guide me
what m i doing wrong
i have cut few s class
ml
clk
all hu64
it always cut wrong using m2 adapter i follow every step on screen...
i dont understand cut by bitting
there is a option
hu64 -2
hu64 -3
how should i place key close to line when i tight the clamp the blade always move alittle back of line ....
daxxer (4th September, 2016)
The database needs amended .. to show where in actual fact you put the key but its common sense really, it cannot clamp firmly if it is not a uniform width so either file the high spot of the key .. or do as suggested move it further back
purdy (23rd September, 2016)
daxxer (5th September, 2016)
Ok I have a SX9 Key
the cuts on the top edge (as opposed to the side edge) have little cuts in them... (think half moon)
whilst the original key has a long low cut into it... in theory it should work, if depths are right...
But it doesn't work! And it wont decode either... Is there update soon Samic.
Mc
Bookmarks