I think your key not succefuly programmed. Try again using avdi or any other tool. Key programing successful, immolight goes off but only car start for 3 seconds
That mean key not programmed successful
Sent from my C5502 using Tapatalk
Toyota Corolla Need check dumps for ECU 89661-02a61 93c86 and 89780-12160 IMMO 93c56
Does anyone have paired dumps for this? Is anyone able to check if the ECU dump is ok?
I checked car and found transponder damaged, I made new transponder with AVDI original TagKeyTool and then immo light goes off but car does not start...
I diagnosed the car and inside ECU is code B2799, so I bridged pins 4 and 13 for 35minutes twice... now the car started few 3 seconds and then cuts out... the fault code inside ECU is still B2799 but car starts and dies before it was not starting at all... any ideas?
ECU dump is attached, please help me...
Thanks
DONT FORGET TO LEAVE THANKS + REP!!
DPF, EGR, O2/LAMBDA, ADBLUE, VMAX/SPEEDLIMIT, CHIPTUNING FOR PETROL/GASOLINE AND DIESEL VEHICLES!
EDC17 VAG IMMO OFF, ECU CLONING, BMW EDC17 ECU CLONING!!!
I think your key not succefuly programmed. Try again using avdi or any other tool. Key programing successful, immolight goes off but only car start for 3 seconds
That mean key not programmed successful
Sent from my C5502 using Tapatalk
Post your immobox data
Sent from my C5502 using Tapatalk
Please see attached the immobox data, I attached before and after adding of the key... I used a virgin 4c chip... would that cause this problem?
DONT FORGET TO LEAVE THANKS + REP!!
DPF, EGR, O2/LAMBDA, ADBLUE, VMAX/SPEEDLIMIT, CHIPTUNING FOR PETROL/GASOLINE AND DIESEL VEHICLES!
EDC17 VAG IMMO OFF, ECU CLONING, BMW EDC17 ECU CLONING!!!
your Toyota is what year?
2005 corolla
DONT FORGET TO LEAVE THANKS + REP!!
DPF, EGR, O2/LAMBDA, ADBLUE, VMAX/SPEEDLIMIT, CHIPTUNING FOR PETROL/GASOLINE AND DIESEL VEHICLES!
EDC17 VAG IMMO OFF, ECU CLONING, BMW EDC17 ECU CLONING!!!
change your eeprom the 93C86
Immo is original , it's not changed ?
Find the dump ECM 93C86 for that car and replace it if it does not start to be replaced eeprom
Hi mate!
How you solved it???
I have a dtc B2799 in ecu and car doesnt start..
The ecu is a denso 89661-02A60 with eeprom 93C86.
I post the dump too.
Can you help me please?
Thank you
Bookmarks