smok uhds always says update internal clock for every operation even after update done has anyone had this? (yes i have internet connection) its been happening over the last 5 days
Oh and by the way if my post has been at all helpfull
please press the little THANKS tab
No i didn't but will try before car go into dealer...
Wysłane z mojego JSN-L21 przy użyciu Tapatalka
Hi
Anyone tried to program keys for Peugeot 508 2011 keyless system?
Thanks
Sent from my MI MAX 3 using Tapatalk
yes mate i changed usb cable and solved..
I have golf5 2007 with burned dash. Tried to adapt used dash, I found pin code,and with VCDS when going in channel 50 after 5min give me access to enter ori car pin code to adapt to engine ecu. When good pin entered vcds write "function not ok" instead to shows ori VIn....
Then I readed edc16 pin ,vin,immo nr,and CS,open sec data from used dash and manually change data,then cheksum and save. Then I put this sec bit ,goes to immo3 entered pin,login...after this all data is changed except mac2,and can't reprogram ori key
Any tips?
Last edited by ziko; 28th January, 2019 at 06:51 PM.
But I changed instrument cluster not ecu,if I change immodata in edc16 then keys will not be able to relearn
Edit: I just saw in help that you are right,in edc16 I write ori car data just to learn mac1,will try next car
Edit: maybe must use new megamos
But lets say I have both pins ori and used dash,why can't adapt with VCdS
I usually put in 25 used dash pin,then adaptation channel 50 to merge used dash with ecu,and after all I reprogram iri keys. In this case not going so,in channel 50 after I put ori pin instead to show on top ori VINetc shows "function not ok"
Last edited by ziko; 28th January, 2019 at 11:09 PM.
Desolder Eeprom and flash from broken dash and move to used dash.
Must be same number and version number.
Fastes way
Skickat från min iPhone med Tapatalk
Bookmarks