Any New's about Dash Golf 7 ?
Knowledge creates mysteries.
Hi. All have an audi a6 edc 17. Ecu is faulty. some can tell how to connect ecu directly to uhds by can? Need to replace it with the doner ecu. I am reading the manual but i don't get it. Please help. Thanks
Sent from my SM-G925F using Tapatalk
[QUOTE=Ocin;2840258]Thank you mate,
I would like to know if eprom read/write by obd work good, do you have this update ?
Thx
Hi i have it read write work good .by OBD but waste your money and buy ioterminal
New option available in Multi UHDS tool Mercedes w222 on OBD with one or two can filters .
mileage1 (7th September, 2016)
Today tested new DSG emulator for newest vag car.
Emulator have to build inside gateway, and read dsg km as dash km.
cokolo (7th September, 2016)
Hi all. I am trying to replace an ecu edc17 and after i put all old and new cs.pin.vin i get fault data changed error 2E. Any one come across this? Thanks
Sent from my SM-G925F using Tapatalk
Car: Peugeot 308 2008y
I tried to block sync BSI<-> dash. The sync block was accepted by the tool, but then it gives an error and the process was stopped (flash corrupted, no VIN, no mileage).
Although the car was "dead", I was still able to communicate with BSI. Backup of flash brought the car back.
I was told later, that the sync block functionality does not work properly. So use it at your own risk
Without "sync block" option it worked like a charm.
Last edited by sendreq; 8th September, 2016 at 10:46 PM.
Yesterday Porsche Cayenne 2013 (92A) 5 minutes job and reset service interval
today I had some problems with 407 jonshon control and c3 valeo. I stoped few times and I had to repeat it , finally it worked after 3-4 times.
I downloaded new all in one soft and update flash interface , hope it doesnt give me problems any more.
has any one used smok for mileage on 2010 vivaro via obd does it work?
Hello
Smok work by OBD in SID305?
I don't know if works by obd decause it's a tricore ECU?
Thanks
Bookmarks