Hello, someboy tried to make w212 facelift with fbs4, does block synchro works on this model?
I tested 3 cars JC (2013/2014), 2 normal cars and one keyless, the keyless car gave problems while trying to flash the dash. The can bus is only 10 seconds alive so the car could not be flashed (init error). Software takes too much time to load the flash and start flashing, car dead but can be solved.
Hello, someboy tried to make w212 facelift with fbs4, does block synchro works on this model?
Bought full Smok and had it delivered today , all I got was UDHS box and obd2 lead , I need to do VW Golf and Passat both with Johnson Controls speedo, do I need JTag or eeprom adapters to sort these dashes or are they totally obd2 now ??
With latest software is JC ZZGolf not 100% OBD2 ??
You need jtag and uhds. look at smok JC manual and you see how it works
I think newer go JC obd2 job. With jtag need reset data area in MCU. Pflash is no problem but Dflash is secured and non programe part. Now not exist way. Its good so slovak sell security access to mcu. If not still is alcatraz.
Now is possible reset only mileage but flashing counter not
Hi Guys, i am newbie. i need to change odometer my alfa 159 2007 Diesel.
what is best possible way to do it??. and can smok do it on dash and ecu???
how idiot proof it is??
thanks everyone.
and you guys seem pros, where can i find a guide to learn this stuff like using programmer etc.
Hi Peko
Alfa Romeo 159 2.4 JTDm 20V
Body Computer Marelli (939)
FIAT
IAW5AF P4 HW 603
I PROBE CHANGE KM in ecm, NO
probe in obd and probe in wiriling diagram smok
identification OK
go service mode OK
probe change km, no change
i read eprom, can help,
now is 107094
please i need 150000 km
regards
Last edited by ekvas; 27th November, 2019 at 08:03 PM.
Bookmarks