aaaaaaaaaa
aaaaaaaaaa
Last edited by samux; 2nd December, 2019 at 08:25 PM.
If I helped, dont forget use buttons reputation+thanks
How is SMOK performing on 2019 model 3008 , I have one to do and I’m fairly new to Smok PSA ??
Did 2019 Peugeot 3008 today , programmed car with Smok and after 5 mins original mileage came back , so removed dash clock and programmed Dash eeprom with DP4 and reprogrammed BSI with SMOK , all worked perfectly
Programmed a 2019 berlingo today With Smok , original km bounced 15 mins later
I need to change passat 2007 MED9.5.10 ecu, ori dead
I read ori pin and CS from used ecu, readed all security data from ori BCM but when go change immo data in smok not going
see image, please some useful info, costumer not wanna open ecu
Init error mean no communcation at all with targer. When you press Read info what happend?
When I press read info or read immo data it read all sec data CS,VIN,....
Tried as med9.1 change immo data passewd ok, but now when read info gID1,ID2,ID3 give some nonsense letters
PIN,CS,VIN is changed as from car bcm but mac1 and mac2 is still same from used ecu not from car
Tried on car and engine start
Last edited by ziko; 9th December, 2019 at 07:02 PM.
Just for info, someone maybe will need it
I replaced many dashes before 2006 and after 2006 on golf5, just read sec from ori and write sec to donor dash and all was ok.
Now I had golf 1.4 marelly ecu and dash not give power to coil and key not seen, I read sec data write to donor dash sec data, but after this (2 donor dashes) when go with VCDS in 25 immo NOT HAVE respond from ecu in measured blocks channel 1 (before I wrote sec data from ori dash respond ecu was YES)
Ori eeprom write not helped to repair ecu respond to YES (one donor was after 2006 other was before)
Then I wrote ori eeprom to donor open sec editor and MANUALLY wrote all sec data from ori dash and saved that sec, After wrote that manually sec data to donor dash all ok, engine respond,key readed etc
Read now donor dash SecBlock and write to orginal, probably on first one cks was damaged or SecBlock itself.
Ori dash only coil problem,sec is ok,but when i wrote ori sec to donor manually then press calc cheksum save then is ok
And why if i have donor and ori pin i enter adaptation ch50 and when enter ori pin it write mailfunction instead to shows vin nr with vcds i mean
Last edited by ziko; 11th December, 2019 at 03:20 PM.
Bookmarks