Upload stock file.
Have you tried to run the car after it?
If you want I can send you a stock file for 2.3T 250HP and make tuning file for the car.
Is the car manual or AT?
Upload stock file.
Have you tried to run the car after it?
If you want I can send you a stock file for 2.3T 250HP and make tuning file for the car.
Is the car manual or AT?
Last edited by konopel; 31st August, 2016 at 08:31 PM.
Fec001 (1st September, 2016)
Car is manual. We tried car after put new parts on the engine, works ok and measured 217HP on dyno. Here I upload stock 2.3T file and the car's stock file.
I think it's enough to copy injection and boost maps from 2.3T to 2.4T file and "riase" some values.
One more question. Have you tried to run the car using software from 2.3T stock?
I have changed some maps. Try it.
But I think you should test stock 2.3T file at first.
Last edited by konopel; 1st September, 2016 at 09:33 AM.
Fec001 (1st September, 2016)
Don't try 2.3T stock flash because I think it will not start the car because of immo. But I will try then...
IMMO is in EEPROM
I've got one of these, did you manage to tune it?
immo in eeprom but when you write other maps to flash cars maybe not start, tested to many cars
FILE SERVICE
Bookmarks