I just got my hands on a chinese clone of the DM800 and am trying to set it up. After searching this forum and other forums thoroughly I cant get my motor to move even if I try and do it sat by sat. Im using Nabilo b/h 0.11.

My cable is very long but the signal is fine. I can move the motor using a tm1000D but even if I use the manual buttons on the motor with my 800hd I get a small click sound from the motor but no movement. I have selected increase voltage.

Could the cable length be an issue. If this is the case I will have to use the tm1000 to move the dish.

This isn't the only problem with the 800hd. Its slow to respond to remote commands and not good with some cams. I hope the real thing isn't like this,

Has anyone got any ideas about moving the motor?