Can anyone identify Pin 1 for me from this photo. I am thinking top left corner should be one. However there is no identifying marks on this chip.
I found a good CH341A Programmer and a good SOIC8 Clip with customizable pinout. I am buying them now. Once they arrive, I will dump the eeprom and post it here. Maybe I can finally get this unit fixed and back into the car. I want to play with the WinCE OS this thing is built on and see what I can tweak.
Can anyone identify Pin 1 for me from this photo. I am thinking top left corner should be one. However there is no identifying marks on this chip.
..........................
SangrelX (4th September, 2016)
Everyone has been a great help. Now can anyone point me to a good software? I was thinking PonyProg but I want to see what other people are using.
Everything will depend on the programmer you use, if you buy the ch341 the ponyprog not work with that,
So that will work with a ch341a? I bought this progrmmer.
https://www.amazon.com/gp/aw/d/B013Q5P3ES
I want to be able to read and flash my 95128 eeprom.
I'm confused because I keep reading that the ch341a can flash 25xxx and 95xxx chips. Are you sure it cant?
What about this one?
https://www.amazon.com/gp/aw/d/B00K7...ID=41nEXIMjOwL
Buy it and you will see
Here is the program for ch341 and see where it says 95128
SangrelX (5th September, 2016)
Last edited by juisro; 5th September, 2016 at 01:59 AM.
SangrelX (5th September, 2016)
I think I understand better. The CH341A can READ the 95128 but it cannot flash it. So I need a different one to actually be able to flash it. The other one I found on Amazon should be able to read and flash the 95128.
Bookmarks