Hi
Can anyone help me to find the Update for CarProg
below the Unit IDs
89170 B2C60
89170 52J30
Version CarProg V9.31
SN :081105CAR001773I
lib file attached 081105CAR001773I.rar
Hi
Can anyone help me to find the Update for CarProg
below the Unit IDs
89170 B2C60
89170 52J30
Version CarProg V9.31
SN :081105CAR001773I
lib file attached 081105CAR001773I.rar
Last edited by isurues; 22nd September, 2016 at 02:10 PM.
post your files here and someone will help you to clear them
Cheers
karolp1993 (30th October, 2016)
I mean srs modules files for clear
Last edited by isurues; 22nd September, 2016 at 05:12 PM.
first step is dont use software version 9.31 with that clone carprog has its hardware for v4.01 software only
second step is read all threads to do with carprog and check yours to see what repairs it needs doing to it
third step is to update to 4.74 firmware so you can use 4.74 software or buy fw from somewhere and update to 8.21
only other option you have is to buy a new carprog (version 8.21)
Thanks for the steps
1.I have Downloaded v4.01 software and connected with the device.
1.jpg
and as you mentioned in as a second step .. i downloaded the 4.74...
so it contains
201213CAR000ME61.lib
CarProg-5.31.exe
so what do i need to do ... just run that files or anythin else
Thank you
No you need to jtag the 4.74 fw to carprog then you can use higher software than 4.01
also look at what repairs your carprog needs
There's carprog threads all over the forum showing what's needed etc
Last edited by tango; 25th September, 2016 at 11:53 AM.
You can use your carprog to read eeprom without any modification. Use software 4.01. Select EEPROM from the left menu, once it loads, click the settings (wrench icon) in upper left corner and select eeprom series you want to read.
If you are getting a lib file error, just make sure there is the correct lib file in the directory of carprog.exe file. Lib file should match your devise serial number
However, the 52J30 toyota module you need to read renesas 1725 processor. Not even full original carprog tool can read these. You need a programmer such as ETL, Carprotool or SMOK to read these
Last edited by repairmymodule; 25th September, 2016 at 05:48 AM.
just corrected my post because for some stupid reason my phone changed jtag to ktag
to put any new firmware on the carprog you need a jtag device to do it most use jlink or wriggler
all info for doing this is on the forum
repairmymodule (25th September, 2016)
I do not know what chip is in that module. If it is an eeprom yes. If it is a Renesas mcu, then no
89170-B2C60.jpg
below the picture of that unit..
Bookmarks