My experience with the Xprog 5.6 clone and recommendations

[nahuel R]

Hi guys, I decided to do this post, to avoid headaches. I recently purchased the Xprog box 5.6 clone, specifically to read MCu SPC560 and XC2361. At the time of reading the MCu did not have major inconveniences, but to my surprise to want to record the new files the program wrote the files wrong, but I rewrote again and again, when for verification always some byte was misspelled . I thought it was a connection problem. Until I was lucky enough to enter the page of ELDB.eu (manufacturers of the original version)


I discovered that you can make your Chinese version original with a few simple steps and at a low price. For greater veneficio the last original version is 5.7.6 with many more MCu possible to read and record



I leave the link to do the registration. Of more this to say that after doing the update and legitimizacion of firmware I was able to record without problems the MCu that I name them


I hope it is useful to you, do not forget to thank

http://www.eldb.eu/index.php?route=p...&product_id=57

[absetup]

are you sure this will not kill the clone?

[nahuel R]

I had the same doubts, so use an old clone that had no use, Xprog m, with a version 1.1 firmware, did not even have a registration code. But as I said before, not only could I update the firmware, but also I generated a registration code and I could register for only 325 euros. Now I have an original Xprog with the latest version of firmware and soft original with all its veneficios. I also have a user in ELDB.us to keep me updated and updated. Hope this can help you. regards: Chuncky:

[nahuel R]

The 415euros corresponds to the registration (325eu) plus an authorization (90eu) since when you register it, you are left with the basic package of authorizations that equally covers all the memories and MCu that already brings the old Xprog
20170104_151101.jpg20170104_160851.jpg

[milkatrek]

I buy yesterday that same package.
all is ok