MPPS 18 ADD YOUR TRICORE PINOUTS/BOOTS

[smirnoff_rules]

as the users off mpps china clones know there a confusion about pinouts to use
most say is the same as fgtech but this isnt the case at all as tricore has a boot wire

what l think could be a help is if members show the pin outs there using on different ecus

on edc17's with single boot l always use ktag pinouts and works fine with no resistor on boot wire

on pcr2.1 i use ktag pinout (with green ign) but not there boot , l found this works fine without resistors http://www.digital-kaos.co.uk/forums...=1#post2949277

please add lads will help others

[roth18]

I use FG Tech / KTAG pinouts, didn't have a problem yet.

[smirnoff_rules]

I use FG Tech / KTAG pinouts, didn't have a problem yet.

l know but which ecu used what