No need, it is quite easy dpf off that car from its own file.
Hi all, i have to delete a fap on a sid 803 from a peugeot 407 2.0 hdi, I know there are softwares from this car with and without fap from stock, does someone know if is it possible to write a file from a sid803 (same model 407 2.0 hdi 136) with out fap on a ecu with fap file?
BR.
No need, it is quite easy dpf off that car from its own file.
ivanrojo (13th May, 2017)
Hi i have just read this ecu with ktag, and i have a problem, my mpc file size is 449kb (looking other files arraund forum they are 452), my problem is my winols does not correct the checksum, but it does on the files downloaded from forum.
does someone know the problem?
Morgano i am working on anual solution for this ecu, maybe is it better to work with a lecture from obd (maybe that way winols will correct checksum correctly)
Btw ecu number: 5ws40167f-t
And read files with ktag, this is my first bdm and i know that?s something very usual arround here it could sound a bit stupid but i can not avoid to be a little proud about me self .
BR.
I have a problem with this eceu, i flashed the modified flile, car sstart and run ok but i have some dtc and when i try to delete them i can?t diagnosis tool says imposible to delete.
dtc are:
comunication fault with bsi
reactivation ecu remote form
unkown dtc.
what could happend?
Last edited by ivanrojo; 13th May, 2017 at 07:20 PM.
With original file those faults are present?
Last edited by teamtuner; 13th May, 2017 at 09:44 PM.
inside forum:ask me about...i will tell you all that i know
make me working for you...i will give you my paypal account
outside forum:
chiptuning,egr,dpf,add blue,dtc,Eu clones
ivanrojo (13th May, 2017)
Hi Morgano i didn?t know yet i bring the ecu to my house tomorrow will try with original file again.
If you have used Chinese Ktag then this problem is inescapable (Chinese KTAG some ECU is not working CK certainly not working on SID803A), now you need the original diagnosis Peugeot or Citroen and online coding would solve the problem (first need to encode BSI, then it needs to encode ECU finally to pair two (online). or the other option is to take out the BSI and ECU and work table.
And flashing again the original file would solve the probelm?
Could someone correct checksum for me? car start and run with this file, if cheksum were not good car doesn?t start up am i right?
Last edited by ivanrojo; 14th May, 2017 at 11:59 AM.
ok, so how can i solved the problem? i don't have diagbox genuine, i have de ecu on bench and can get the bsi on bench too
Last edited by ivanrojo; 14th May, 2017 at 02:11 PM.
I hav just test it with original file, some problem plus fap fault code again...
So fap off should be ok, problem is on bsi as macako said.
Hi all, at the end i damaged old ecu, so i gad to buy a new one, some sw and hw, I cloned the ecu, flash and eprom for old ecu and mpc from a virutal read (same sw and hw). Car doesn?t start and is not able to comunicate with diagnosis tool.
Does someone know if problem could be for using flash and mpc file from diferents ecus?
Bookmarks