Thanks mate. The file in s93c56 is corrupt. I did not read in board. I suspect I didn't solder it well b4 programming. Can use another dump from another cluster
You can try another dump but you lost immo in dash so car will not start. I hate to say this but you may start experiencing what many of us call "a bad day."
- Remember Don't Just Sit There In Boredom, Add to the Forum!!
upload another dump from same dash
use sbb or x100pro to adapt key
you have yo choose all key lost... and this is require to program 2 transponder key
or if you have tango you can program 1 transponder key
GOOD LUCK
IF MY POST WAS HELPFUL DON'T FORGET TO GIVE ME LIKE AND REPUTATION... THAT WILL KEEP US HELPING OTHER'S
Dejfat (13th June, 2017)
eliaselias - and what with synchro with ecu?
Dejfat (13th June, 2017)
closet I have:
05 mazda 3.
Attachment 456450
here is from 2008 Mazda 3
Attachment 456452
Should just be able to use IDS or other diag tool to adapt the cluster (perimeter reset) and add key(s) after.
some models do not require perimeter reset and just need to do clear/erase tho I do not know if this is one or not.
Last edited by narkeleptk; 13th June, 2017 at 06:07 PM.
Thanks I will try and will report back
here is the dump saved on digiprog. key flashing in dash, mileage shows dash. car not starting.
tried another dump Got error code B1601 FORD - PATS Received Incorrect Key-Code From Ignition Key Transponder
l
SDo i need to Sync Ecu With Cluster
Last edited by Dejfat; 13th June, 2017 at 10:04 PM.
that code just means you need to program key. which was part of the process of replacing the missing dump
Dejfat (13th June, 2017)
do all key lost... you can program same key.. but you need to program also another one
IF MY POST WAS HELPFUL DON'T FORGET TO GIVE ME LIKE AND REPUTATION... THAT WILL KEEP US HELPING OTHER'S
Dejfat (14th June, 2017), narkeleptk (15th June, 2017)
Bookmarks