Code for Lexia - Citroen C3 2004 BSI

[imocanin]

hello

Please can you help me with code for Lexia...i need code to configure BSI
I have code 9GW3 but Lexia ask me 5 digits code...

Dump from BSI:

dump_bsi.rar

Thanks

[doctore]

Tr pin code 3WG9

[morfej]

5digit code : 03114

[juggleres]

5digit code : 03114

Hello,

Is it possible to match another cars ECM (same numbers) with this 5 digits code (03114) via Lexia? Could immo work after maching?

Thanks in advanced!

[ilian_cho]

This code is using when change configuration in bsi-citroen. For maching you need immo(pin) code-4 digit.

[brend]

This code is using when change configuration in bsi-citroen. For maching you need immo(pin) code-4 digit.

Its correct this code (like 03114 ) for only bsi coding not for mach and swap.For maching need 4 dig. code ( like 3WG9 ​).

For another ecu mach need virgine donor ecu.

[juggleres]

Thank you very much!

I bought a BSI+ECM+ign. set and I know the VIN of the donor vehicle. I can change the VIN in the BSI. If I change it the PIN code will not change, becouse PIN is in the ECM immo and it is originate from the first cars VIN. (So if the donor car has not the original ECM I could not use the donor's PIN from VIN.) What should I do? Buy KESS/KTAG or is there any similar solution?

Many thanks!

[brend]

Thank you very much!

I bought a BSI+ECM+ign. set and I know the VIN of the donor vehicle. I can change the VIN in the BSI. If I change it the PIN code will not change, becouse PIN is in the ECM immo and it is originate from the first cars VIN. (So if the donor car has not the original ECM I could not use the donor's PIN from VIN.) What should I do? Buy KESS/KTAG or is there any similar solution?

Many thanks!

No.
KESS/KTAG Only read/write (Flash,eep.,Mpc) for work need another dump tools.

[ssemmedo]

i have similar problem. i bring bsi, ecu and ignition from another car, te car started ok but folding mirror, fuel flap and rear windows are opening when i start the car. i try to make configuration with diagbox but did not work. higth frequancy key remote is not working as well. i need help for the bsi to work is this car. They send me the bsi from outside my country i think they send me bsi from citroen c4 and my car is citroen c4 picasso.

[yvesdu56]

hello

i have the same problem with Lexia...i need code to configure a new BSI siemens e02
I have code 4 caracters but Lexia ask me 5 digits code...
thanks a lot
Dump from BSI:

[ilian_cho]

Loock at post #3

[Bllinda]

Below is a courtesy button

hello

i have the same problem with Lexia...i need code to configure a new BSI siemens e02
I have code 4 caracters but Lexia ask me 5 digits code...
thanks a lot
Dump from BSI:

[yvesdu56]

Thank you very much for the quick response
i ll try this afternoon