did you try dpf reset with diagbox ? do fap changed and reset .
Hi i do have a problem with Peugeot 308 1.6 HDi 92 KM 2010 i have made a Stage 1 Chiptunning on 110KM an do atached an oryginal and moded file.
But the customer says that when he do accelerate than the message on dash shows up:
"Risk of particle filter blocking fault"
what is bad made in the Map ?? I have made a cleaning of DPF throught OBDII software but the problem comes back after a three days.
The customer is not willing to remove the DPF. What can be done better in program? I have started since may and still been learning....
Can someone edit it a good way probably with lower Power but without fault.??
Thanks in advance!
did you try dpf reset with diagbox ? do fap changed and reset .
kubuswujo (21st August, 2017)
I have made a DPF clean (10 min) 4000RPM and than 3 minutes idle speed. With Delphi and Vpecker.
Should I do after it a DPF reset?
i do think that I should lower some values in Map but do not know what is the issue and do not want to low everything.
Mate, don't want to sound rude but... you should learn BEFORE messing with CUSTOMER'S cars, not after.
kubuswujo (21st August, 2017)
Yes, I know You are right iwas on the chiptunning curses, but this is my first time i got problem with customer so probably someone can make a stage 1 using oryginal file and
I will study on myself that file and how it should be made.
pike (21st August, 2017)
If car have 160-170kkm You must only reset DPF on diagnostic tool. It is normal info with this mileage
Bookmarks