I only get unsupported command.
I only get unsupported command.
CAN I use interface vag com 3.01 ????
I can't get it to work with Mprog. Only FT_Prog, but ftprog doesn't load ept files. what do I do?
In Mprog i get the message FT_open - invalid handle.....
My cable was damaged and not detected any FTDI device. I replaced FTDI chip and everything works ok after adjustment mprog.
i need for dump vag-tacho v 3.01
The 3.01 are junk took 4 untill one worked and the case was boxxy.
...
still looking for a good 3.1 dump or higher
atb
Hello!
recently bought this cable:
VAG TACHO 3.01 + USB OPEL IMMO EEPROM | eBay
Anyone know what software you use?
TNKS A LOT!
El Cordobe!
RASCH MotorSport
laki23 (11th November, 2019)
Hi guys,
I bought this cable about 2 years ago and never got it to work
I just fished it out to give it another try on a new laptop, but still the same- usb to k line interface not found.
I tried several different software versions, but still the same.
I see a few posts up that someone had this prob and changed id???? how??? where??
Thanks for any help guys,
happy new year
ninja
DK- The Bogs Dollocks!!!
NEVER SAY IT CANT BE DONE!!
The thanks button works wonders!!
DONT SEND ME PM'S ASKING FOR OTHER MEMBERS WORK OR PASSWORDS
You can`t use different softwares, only version which comes together with interface (china clone).
3,01 from last site don't work in my VAGTacho, ATMega dump is interrupted or something.
Bookmarks