Did you just clear line 580 through 5F0
Cleared crash from SRS unit 77960-D310-M1 from 2007 Accord.
After installed on car, besides the errors to recalibrate seat also fault came up 'internal failure of SRS unit" .
Is this due to incorrect clear of dump or some internal hardware failure inside the unit?
Did you just clear line 580 through 5F0
borshch (24th October, 2017)
Sure you cleared more.
Airbag crash/clear file Service.
borshch (24th October, 2017)
here, I have original Crash dump.
plus have 2 cleared files:
one Cleared by tachosoft online.
and one cleared by Airbag Service Tool.
I think i programmed the tachosoft one into the module, but dont remember exactly which one i programmed in
but the cleared files are very different.
dont know which one clears correct.
so best to clear manually only line 580 through 5F0 and leave everything else untouched ?
You want to clear through line 580 all through 5E0.
Leave line 570 and everything above. Leave line 5F0 and everything below. 5F0 starts OPDS info
borshch (25th October, 2017)
if is made by TRW. module was overheat releasing voltage to deploy airbags....until now there is no solution what get burned...some people said flash mcu.. Get corrupted..mcu spc or renesas h8sx with external eeprom...but if you read cpdes before remove ot u3000.49 ita already recorded
Remember all my post, comments and files are for educational purposes only , you take your own risk using my post and files
Did you even look at his dumps? They are incorrect. Will cause 51-xx. The u3000 code you are referring to are common in the newer, 2013+ CIVIC modules....
http://www.digital-kaos.co.uk/forums...ou-help-thanks
http://www.digital-kaos.co.uk/forums...with-U3000-dtc
Last edited by repairmymodule; 26th October, 2017 at 06:43 AM.
borshch (28th October, 2017)
Strange that tachosoft doesn’t clear this correctly either. I used to trust tachosoft-online, but not anymore
Even using virgin dump..does not fix it...
Remember all my post, comments and files are for educational purposes only , you take your own risk using my post and files
Disconnect driver airbag..read codes driver airbag open in two plugs. And u3000 . clear codes.. Gone..no more u3000. On off switxh many times..drive the car. Off read codes no u3000 only driver airbag.. Module detects shorts in driver airbag...but is not the airbag..resistor plus capacitor plus etc...
Remember all my post, comments and files are for educational purposes only , you take your own risk using my post and files
borshch (31st October, 2017)
got the module from the car. tried to read the code from eeprom, but eeprom is corrupt. with UPA i get all zeros, with iprog+ i get random Ff and 00 everytime i click read it reads diferently, with arlabs I get all 00.
what could have happened here?
is it repairable ?
I still have original code with crash saved on computer.
is it safe to write it into the the eeprom or the actual eeprom chip maybe damaged ?
or to get new 95320 eeprom chip fo the module ???
Last edited by borshch; 31st October, 2017 at 06:55 PM.
Bookmarks