20% of torque is ok.
20% of torque is ok.
Chiptuning - Diesel / Petrol / Stage1,2,3 / HIGH Petrol Tuning
DSG TUNING
DPF / EGR / TVA / SAI / Lambda
Crackle map ( Launch Control + No lift Shift + Antilag )
File Service
PCMFLASH / BFLASH / AMT BST / AMT MPPS / TGFLASH / BITBOX / EDCSUITEPRO - Genuine USER
Mate, i say around 20% When i correct maps, And i look later at this in % Its always around 20%,
Wysłane z iPhone za pomocą Tapatalk
Chiptuning - Diesel / Petrol / Stage1,2,3 / HIGH Petrol Tuning
DSG TUNING
DPF / EGR / TVA / SAI / Lambda
Crackle map ( Launch Control + No lift Shift + Antilag )
File Service
PCMFLASH / BFLASH / AMT BST / AMT MPPS / TGFLASH / BITBOX / EDCSUITEPRO - Genuine USER
For sure not constant level. It depends on engine. I never do full increase on low rpm's due to surge of turbo or DMF destroying. Also there are some drives which does not like high torque, but the power could be not low. For example last time I was doing AJM engine with ASZ turbo and IC, max achieved torque was 347 Nm, but with power of 168 PS. Flat torque, compeletly diffrent from ori. Also some engines could not do even 20% of increase.
Autotuner user
Kess/Ktag
WinOLS
thank you guys, what I meant is I am still not able to determine which torque value is my stock torque
what I usually do is looking into FAPS Map and fuel quantity map, then I consider my stock torque value not to exceed highest torque in fuel quantity map.
I know it is not clear, but this is where I am.
Bookmarks