I want to write 117095 it read 171010.
I used the Tachosoft Calculator, but I guess it is wrong.
What are the lines to edit in this dump file?
Thanks in advance.
I want to write 117095 it read 171010.
I used the Tachosoft Calculator, but I guess it is wrong.
What are the lines to edit in this dump file?
Thanks in advance.
here is your file
May I know what software do you used?
Tacho Calculator gives the wrong lines. I have tried in 2 different Sentra, same year, and always read 600K.
Please.
wincalc ok for serious work
I do no want to bother, but let me know if you can help me with the follow.
I wrote the code to the chip. Then I read it again to check if updated correctly.
Then I soldered back to the cluster, and read again 600K. I re-read the eeprom and now the data is different.
I am using a Digimaster 3 to write the eeprom, I have used it before with others chips and so far I have not had any problem.
Thoughts?
Excuse my English.
unsolder eeprom
and use a good programmer
1. upa
2. orange
There is chance that the DigiMaster 3 is writing incorrectly the eeprom?
This only have happened to me twice, with the same car model and the same eeprom. No matter what I do, I even used the Tachosoft to write 10K miles to check what it write and it only change by some numbers.
Not sure if I am explaining correctly.
I appreciate your reply very much.
Miniprog can do the job? With a good clip adapter? In circuit
Bookmarks