P307 1.4hdi no start after wiriting with fgtech galleto

[rfernandes]

Hi there...
After wiriting a new file via obd the car wont start and the engine light dont show..
After i read via bdm(ktag) and read all ecu..
Any help?
Many thanks..

[morgano]

Upload first obd reading and after block bdm reading.

[rfernandes]

what do you mean on block bdm mate?

[morgano]

I mean bdm read of the blocked ecu after you wrote the tune by obd.

[rfernandes]

ahh...ok..
here

[morgano]

No mate, is needed BDM read of the ecu in its actual blocked state.

[morgano]

No matter, found a backup.

Upload this one to ecu using KTAG or FGTECH in BDM mode. Ecu should be alive again. Pass is same as your last file.

Regards,

[rfernandes]

i´ve wrote tha one i sent you mate..it goes to 99% and ingnicion just go off..
tomorow will wrote that one
many thanks mate..ill back to you when test

[rfernandes]

thanks morgano!!!the car start!!!cheers mate!!