op com firmware 1.39?

**balazevicantus** · 17th April, 2018, 01:49 PM

does everyone have firmware 1.39 for opcom?

**Mario6** · 17th April, 2018, 08:21 PM

Hi.
Firmware 1.39 is needed for cooperation with OP Com China Clone 082010. After being used with the Vaux Com 2014 software, firmware will be automatically updated to version 1.45. There is one condition. The Opcom interface must have a programmable PIC 18F458. If it is not programmable then the opcom will be damaged.

**gerinemo** · 28th April, 2018, 07:30 PM

Firmware 1.39

**radulescuraduflorin** · 30th September, 2018, 09:12 PM

hi all.can someone tell me wich version of opcom is best to use for reading security codes from opel ecu,s?Thanks in advance for your answers.

**osmanek** · 14th March, 2019, 02:28 AM

thnx
gerinemo

**electronistul21** · 14th March, 2019, 12:16 PM

opcom can read codPIN only to Corsa C.For this need use opcom with FW 1.39

**ajc123** · 30th September, 2019, 11:45 PM

Originally Posted by gerinemo

Firmware 1.39

Thanks very much for this!

**hector3** · 27th February, 2020, 06:13 AM

Originally Posted by gerinemo

Firmware 1.39

Will this fix my cluster communication problem?

**cojna** · 2nd March, 2020, 12:21 AM

is it possible to download op com FW 1.39 or I get divorced

**lister2020** · 22nd April, 2020, 09:57 AM

thanks been looking everywhere for this

**Choko67** · 28th December, 2020, 03:44 PM

gfhfyjgjgjgj

**nahok** · 1st January, 2021, 09:37 PM

FW 1.39 thanks ,

**andy996tt** · 19th March, 2021, 04:38 PM

Originally Posted by nahok

FW 1.39 thanks ,

Thanks for the FW

**Castrol R** · 23rd March, 2021, 01:47 PM

Many thanks for this firmware I have been looking everywhere for this. I am using what I think is a !.7 version of device, (it has the white wires wires internally and a proper pic chip). I am using it on a 2011 diesel turbo 1.3 Corsa D and 1.65 firmware with windows 10, interface test ok but cannot read ecu parameters although other modules are ok. Can reset error codes though, and have tested OBD socket with multimeter and is correct (60ohms and correct voltages) I will flash this FW and see if it works any better.

**Mario6** · 23rd March, 2021, 04:57 PM

Originally Posted by Castrol R

Many thanks for this firmware I have been looking everywhere for this. I am using what I think is a !.7 version of device, (it has the white wires wires internally and a proper pic chip). I am using it on a 2011 diesel turbo 1.3 Corsa D and 1.65 firmware with windows 10, interface test ok but cannot read ecu parameters although other modules are ok. Can reset error codes though, and have tested OBD socket with multimeter and is correct (60ohms and correct voltages) I will flash this FW and see if it works any better.

Hi
Firmware 1.39 is designed to work with SW Opcom China 082010 and lower. If you have Opcom China clone with real PIC 18F458 and you use SW Vauxcom 120903a your FW will be automatically changed to 1.45. .