Here is BDM 100 Update

[butthead]

Which update is BDM clone killer and which is ok , confused??

[pablo1971]

can someone just verify if my bdm is working or not.....when its connected to usb i get the id in device manager"MAP3DOBD".but when i connect the power cable and run the program i get no LED lighting up,tried on a ecu and its the same....i think its dead...

[2200]

Which update is BDM clone killer and which is ok , confused??

same question.

thanks

[RaraK]

hello!
now i tried it on an other PC and the update was sucessful.
but i have another problem (see picture)
i connected to the ecu like it shows in the cmd bdm100 manual.
i have external 12V power on bdm100 interface.
also tried to give power to the ecu (ME9.1)
always same fault.
anyone can help?
many thanks

BDM port fried on ECU, verify voltage and connection, try on a new ecu if you dare!

[electrix]

Hi, I attached 100% working BDM update. I have BDM working with CMD 1255 SW. Yesterday I tried it with Dimsport software and after that it stopped working with CMD - I saw error about too old software. So I ran 2.exe then 1.exe from archive I attached and it works perfectly again with CMD 1255.

[pandokrator]

i have read about differences between original and clone
bdm 100 ,some people talking for different pinout from bdm.
I'm confused but i need some cheap tuning tool (beginner),
were can buy a "good" copy-clone bdm 100 from europe ?
what is the "tricks" and must careful about product ?
thnx in advance

[miha99]

Buy xprog-m and no confusion with pinout.

[pandokrator]

you mean clone xprog-m ?
because i found it from two thousand
bR

[miha99]

Yes clone, It works reliable with EDC16 via BDM port.

[rajivc666]

Thanks guys wealth of information.

[vasycara]

BDM100 clone works nice.Today read/write ok fiat doblo 1.3 mjtd+ ecu 6f3.It is a good tool for bdm.

[twinchoke]

unable to access this site is there another link ??