ORI will do this no prb, are you trying with a clone?
Hi, im trying to use digiprog3 on w212 (2010). but it wont read the real data from tacho or EZS. it reads : "OLD :1948032 km"
and if i type in new km 250 000. it shows :"check written value 1995776"
and it does not change anything on my cars tacho.
digiprog is v4.94
any suggetions?
Thanks!
image1.jpg
Last edited by crspotest; 28th May, 2018 at 04:41 PM.
ORI will do this no prb, are you trying with a clone?
Yes its a clone. but it did the job last time, for the same kind of MB w212. This is the same year and black and white display.
I just cant figure it out, why it reads such a big number of km ?
....maybe the car has a blocker installed....
Last edited by Cllau; 28th May, 2018 at 09:12 PM.
Drive the car up to 16 Miles then try again but make sure the car is started
I mean programme while Engine is running
Sent from my iPhone using Tapatalk
Did that. no result. Same. it reads about 2 million km. and cant change.... damn
step away from that car m8 will give trouble....
Digiprog put 1600000 on EZS. You need another tool to do EZS km.
If i help, d'not forget to press thank button!!
Kocta (1st June, 2018)
use better tool. or install canfilter.
Well you dont need can blocker to programme till 2013
Basically you need another tool to programme this
Sent from my iPhone using Tapatalk
Last edited by Happy786786; 29th May, 2018 at 10:09 PM.
cristyand (18th June, 2019)
MileageAudit5 (28th October, 2022)
Thanks guys. yesterday one friend came by and tryed with OBDstar x300m and the same result.
He tgought that it needed to take tachometer apart, and to the direct programming to chip.
is there anywhere DIY instructions?
Thanks for all the info.
Will give you update how it goes
Why keep trying cheap China tools? Use a real good tool. Or program eeprom and use canfilter!!!1! Problem solved
kachimbi (26th January, 2019)
Bookmarks