5008 seat belt airbag error message

[zecopeca]

Hi there, I have a bit of a problem and wonder if any of you can help.

Some time ago I replace both seat belt airbags and cleared crash data from airbag module.
On the passenger seat belt there is a pretensioner and I put a resistor there. All good and no problems.
Yesterday I went over a bump in the road quite hard and now I have the airbag light on with also a message saying seat belt airbag has a problem.
Both seat belts are good. I have replaced the resistor in the pretensioner just in case but still light and message are on.

Did this bump caused crash data in the airbag module and I need now to reset the module and clear crash data?
What else could be causing this error message and light on?
This is for a peugeot 5008 (2010)
Many thanks in advance

[megabits]

Hi there, I have a bit of a problem and wonder if any of you can help.

Some time ago I replace both seat belt airbags and cleared crash data from airbag module.
On the passenger seat belt there is a pretensioner and I put a resistor there. All good and no problems.
Yesterday I went over a bump in the road quite hard and now I have the airbag light on with also a message saying seat belt airbag has a problem.
Both seat belts are good. I have replaced the resistor in the pretensioner just in case but still light and message are on.

Did this bump caused crash data in the airbag module and I need now to reset the module and clear crash data?
What else could be causing this error message and light on?
This is for a peugeot 5008 (2010)
Many thanks in advance

Replace the seat belt tensioner. Then reset the crash file. The error was probably recorded in the file. For more accurate information, it is best to post a photo of the SRS module label.

[zecopeca]

Thanks Megabits
Here is a pic of the SRS module.
IMG_2832.JPG

[slick_dick]

dont use resistors always best to replace components

and you would really need to diagnose the issue with a good scanner in order to know exactly what the issue is

[zecopeca]

Yes resistor is temporary until I find a second hand one. Is there a way to check if there is crash data in the SRS module?

[slick_dick]

diagnostics only

read faults and post here

use a scanner to find the exact cause

[zecopeca]

Ok thanks all.
I have replaced pretensionner and cleared crash data in the airbag module. Light is no off and all working.

Many thanks