Hi there, I have a bit of a problem and wonder if any of you can help.
Some time ago I replace both seat belt airbags and cleared crash data from airbag module.
On the passenger seat belt there is a pretensioner and I put a resistor there. All good and no problems.
Yesterday I went over a bump in the road quite hard and now I have the airbag light on with also a message saying seat belt airbag has a problem.
Both seat belts are good. I have replaced the resistor in the pretensioner just in case but still light and message are on.
Did this bump caused crash data in the airbag module and I need now to reset the module and clear crash data?
What else could be causing this error message and light on?
This is for a peugeot 5008 (2010)
Many thanks in advance
In case my help has been useful do not forget the magic buttons. ( Thanks and * Reputation ) !!!.
ATTENTION!!!
Attempting to clean files is only to help members. By using these files, you agree to assume the consequences and are aware that all liability for any damages is entirely yours.
Thank you!
megabits.
zecopeca (29th June, 2018)
Thanks Megabits
Here is a pic of the SRS module.
IMG_2832.JPG
dont use resistors always best to replace components
and you would really need to diagnose the issue with a good scanner in order to know exactly what the issue is
Last edited by slick_dick; 29th June, 2018 at 11:57 AM.
“There's nothing more dangerous than someone who wants to make the world a better place.” ― Banksy
Yes resistor is temporary until I find a second hand one. Is there a way to check if there is crash data in the SRS module?
diagnostics only
read faults and post here
use a scanner to find the exact cause
“There's nothing more dangerous than someone who wants to make the world a better place.” ― Banksy
Ok thanks all.
I have replaced pretensionner and cleared crash data in the airbag module. Light is no off and all working.
Many thanks
Bookmarks