forc focus 2001 hc11

[diagtech2000]

hello,

ive got a ford focus 2001 with a hc11 micro,

on all of my diagrams for the dp3/digiprog show 1 point on the back of the board to connect 1 wire to, (tp3 or tp46)

but the board is different, its got no writing & the points where the wire should connect to are different?

can anyone tell me the correct point to connect to for this version ?
cheers




Sent from my iPhone using Tapatalk

[Happy786786]

It supposed to be Dash Diag Hc11



Sent from my iPhone using Tapatalk

[diagtech2000]

yes it isbut you still need to connect 1 wire on the back of the board


Sent from my iPhone using Tapatalk

[dashradio]

Here is your picture marked, I would try the arrowed one first but if that doesn't work try either of the other two in the circle.


Sometimes when I have tried to do these with the DP3 (Diaprog)
It has not work unless I powered the dash via 12v not from the DP3,
(by the way Elprosys do not recommend that you do it this way)

[diagtech2000]

cheers just tried the arrowed without giving it external power,

now it’s showing error where the mileage was displayed?


Sent from my iPhone using Tapatalk