Hu58 lishi stuck in ignition lock cylinder

[p1et]

Hi,

I picked and removed ignirion lock cylinder from the housing, decoded and now I cant release my tool from the lock. I turn it back fully to 0 position and its stuck
What is the matter? I have never seen this and was practising a lot on this locks before...

https://youtube.com/shorts/3jV3Gl8i5...yBTmAtTuZ11EW3

[rapidlocksmiths]

ive never had this on hu58 , have you tried applying light tension to off position and feel each wafer position to see if one needs picking or is out of place ? is vice clamped too tight ?

[p1et]

Yeah, Ive tried exactly what you mentioned and actually felt 1 wafer (No.2) being able to pick backwards which I did but that didnt help. I thought that the white piece which is located at the front of fhe barell was blocking, I tried to move it bu putting something flat in between but no any results so I cut the outer ring, pull it as much as I could and hit the barell with Hammer underneth where the ring was and finally it give me the result, I was able to pull out my lishi.

Of course I decoded the lock correctly, the cut key was the right one...

Now using correct key, it also blocks, need to pull key with some force to be able to remove it. However only if I turn it towards and then backwards. If key is out and I only put it in, I can remove it easily. The problem happens only when turn it towards and then backeards to release. So probably a wafer problem but I didnt care, its too old to bother, not for the money I get for this job anyway... Although could have jusy threw out that 1 wafer but nvm, it works...