Reply With Quotejackieboy8 (20th August, 2018), Johnner (20th August, 2018)
Results 16 to 17 of 17
Thread: 93C86 in circuit writing
-
20th August, 2018, 08:47 PM #16DK Veteran
- Join Date
- Feb 2010
- Location
- Germany
- Posts
- 755
- Thanks
- 112
- Thanks
- 515
- Thanked in
- 347 Posts
Yes, you can resolder with hot air also. Just buy a flux pen. Make some flux to the solder pads, put eeprom on pads, and make it hot. The eeprom will swim to the right position. Buy a good station, where you can set the temp. Otherwise your can overheat eeprom and pcb. Make training with some old pcb´s.
Greets MR...
-
The Following 2 Users Say Thank You to brobble For This Useful Post:
-
21st August, 2018, 04:28 AM #17DK Veteran
- Join Date
- Jul 2010
- Location
- melbourne, australia
- Posts
- 1,043
- Thanks
- 421
- Thanks
- 232
- Thanked in
- 157 Posts
the problem is the risk of corruption. if you lose the dump you are in a world of hurt. safer to desolder & only takes 5 minutes anyway
personally, I always desolder, sometimes, once ive got the dump & will try to read in circuit so I know for next time
Bookmarks