zgemma help
Register
Results 1 to 6 of 6

Thread: zgemma help

  1. #1
    Newbie
    Join Date
    Jul 2011
    Posts
    3
    Thanks Thanks Given 
    0
    Thanks Thanks Received 
    0
    Thanked in
    0 Posts

    Default zgemma help

    hi my zgemma box only works for a few mins then says no signal was working fine subs are ok changed splitter and wire but still doing the same can anyone help plz

  2. #2
    Junior Member
    Join Date
    Jun 2018
    Posts
    26
    Thanks Thanks Given 
    21
    Thanks Thanks Received 
    0
    Thanked in
    0 Posts

    Default

    Is it overheating ?
    Had a receiver with similar behaviour like yours and it was running too hot. Try to check if it is hot and just temporarily remove case and put a fan on it to see if heat is the problem.

  3. #3
    Newbie
    Join Date
    Jul 2011
    Posts
    3
    Thanks Thanks Given 
    0
    Thanks Thanks Received 
    0
    Thanked in
    0 Posts

    Default

    thank you looks like it is over heating is there any repair for it or is it time for a new box

  4. #4
    DK Veteran
    joe516's Avatar
    Join Date
    Mar 2008
    Location
    manchester
    Posts
    1,000
    Thanks Thanks Given 
    821
    Thanks Thanks Received 
    474
    Thanked in
    257 Posts

    Default

    Quote Originally Posted by gof1 View Post
    thank you looks like it is over heating is there any repair for it or is it time for a new box
    new box...……...
    information given is to be used for educational purposes only
    Don't Forget To Say Thanks If You Like My Post
    IF YOU THINK A POST HAS BEEN USEFUL USE THE THANKS BUTTON
    If It Ain't Broke Don't Fix It

  5. #5
    Junior Member
    Join Date
    Jun 2018
    Posts
    26
    Thanks Thanks Given 
    21
    Thanks Thanks Received 
    0
    Thanked in
    0 Posts

    Default

    Indeed there is no fix. You can try to use a fan powered from 5volt from your receiver. Be carefull where you take those 5Volts because you don't want to take power from chipset for example. Would be better to take 5Volts nearest from source.
    Don't know zgemma receivers but it might help to remove heatsink and put new heat conducting solution because the one which came from factory is probably damaged from heat and is quite hard now leaving your cpu without contact from heatsink thus resulting in poor heat transfer. Let's hope this receiver has some kind of heatsink which can be removed without desoldering.

  6. #6
    DK Veteran lincsat's Avatar
    Join Date
    Jun 2008
    Posts
    1,228
    Thanks Thanks Given 
    0
    Thanks Thanks Received 
    181
    Thanked in
    137 Posts

    Default

    No signal is unusual for Cable, usually they pop up a "Tune Failed". It's common on a poor Cable signal. You could have a dodgy tuner, you can also try another PSU.

 

 

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
This website uses cookies
We use cookies to store session information to facilitate remembering your login information, to allow you to save website preferences, to personalise content and ads, to provide social media features and to analyse our traffic. We also share information about your use of our site with our social media, advertising and analytics partners.