Pegouet 405 with Sagem s2000 ? Wrong car typing or Sagem SL96 ?
Pegouet 405 with Sagem s2000 ? Wrong car typing or Sagem SL96 ?
NO.it is correct.
pegouet 405 with engin xu7.
this car is product 1998.
8 Cylinder.
1. (XU) 7 stands for 1.8 litre engine
2. The ECU Sagem S2000 in year 1998, it has not yet born !
3. PSA has never produced 8-cylinder engine (if yes, they could be in just after world war II era !). And by any layout of 8-cylinder engine, do you think it can be fitted transverely in 405 bonnet ?, or you meant 8 valve ?
Meat-Head (15th December, 2018)
Sorry i mean 8 valve
I looked more closely and see engine is produced in 1998.
But there's no doubt about the Xu7 engine.
photo_2018-12-15_08-58-16.jpgThe car may be assembled in the near future.
Last edited by bahar5312; 15th December, 2018 at 11:10 AM.
I've checked with autodata and sedre (peugeot official doc source) and found no model fitted with S2000. I don't know where you located, but just know that in middle-east they keep producing 405 till now or recently (?), that they might adopt this newer ECU in. But I have no info!
i found map this ecu
SagemS2000Map.jpgwhat problem in ecu can be that no work oxygen sensor .
yes i live in middle-east.
Last edited by bahar5312; 15th December, 2018 at 02:46 PM.
Meat-Head (15th December, 2018)
What did you find the problem, heater driver or sensor part? and to which sensor, up or down stream ? Better if you know the fault codes
Presume that you knew the ECU pinout for the problem sensor, are you sure that if I provide you the connection routing back to inside the PCB then you can manage to repair. You knew that the PCB is fully potted with thick rubber !
yes i know PCB is fully potted with thick rubber.
i change ecu and see was good Oxygen sensor values in Fault diagnostic device GSCAN2.
I want to know that this problem is solved with the program eprom or Or this problem has nothing to do with the program eprom.
You want to repair or replace ? Understand that you have a new used one in hand so suggest to replace.
Two ways to go with, cloning eeprom and by virgin eeprom and use PP2000 to adapt the ECU to the car. Anyway, I'm not sure that is possible or how to do exactly on this old odd car !
btw, as I don't see you doing some thanks so you should help yourself digging for the needed info!
i want repair.
The first thing that comes to my mind is cloning eeprom.
i will do it.
Last edited by bahar5312; 18th December, 2018 at 11:30 PM.
Bookmarks