Good day friends
I have cas3+ from bmw e90 and need to do mileage correction.
But when I try to read with R270 I get ID error
Someone could please help it would be much appreciated
Sent from my HUAWEI CAN-L01 using Tapatalk
Good day friends
I have cas3+ from bmw e90 and need to do mileage correction.
But when I try to read with R270 I get ID error
Someone could please help it would be much appreciated
Sent from my HUAWEI CAN-L01 using Tapatalk
Double check the wire connection, i have same problem on CAS2 checked again wires, resolder it and go great
Man check 7 wire i'm think you get it wrong, R270 have bad pictures, you need to solder it to board pin check please
Use microscope to see pins
did you give power to R270??
if you tr many time with this tool
probably you will not fire car again it will kill mcu
Professional bmw key service cas 3/3+ 4/4+ repair = reset ews egs 8hp = 6hp-egs19d
Do you mabe have pinout for R270
Mabe I have bad wire adaptor..??
Then I can mabe try female jumper wires
Sent from my HUAWEI CAN-L01 using Tapatalk
here you goo check your wire on r270 plus gnd and rest0b210901d401f4fe3f007dffa8522953.jpg
Professional bmw key service cas 3/3+ 4/4+ repair = reset ews egs 8hp = 6hp-egs19d
Bookmarks