2004 citroen xsara picasso - how to get pin?

[sdnatlst]

Hi all, anyone help how i will get the PIN from OBD possible?

2004 xsara picasso, 2 button remote key.

MVP pro says it codes the key, but will not read the pin code



is it eeprom job only to gain pin code?

[ghostrider72]

SMOK toll can do that over OBD.

[jodge]

the easy way when you take out the ECU hard way when you take out the BSI
or you can buy the pincode from the dealer

or you can read from the ECU if the can lines are available (MVP not supported)

[jodge]

SMOK toll can do that over OBD.

only when it's siemens and you need to do the ecu connections too, bcose the CAN lines are missing from the OBD socket

[sdnatlst]

thanks, i will have to try with OBD , i have Lonsdor tool too, i hope it works.

i quoted very cheap for this job as such old car, didnt realise pin code was sometimes difficult for them

[ghostrider72]

only when it's siemens and you need to do the ecu connections too, bcose the CAN lines are missing from the OBD socket

Im pretty sure I’ve done few K-lines with Smok as well.

[Jimmy07]

Looking at this too. I’ve sent for cables for TDB1000 to read pin from ECM without removal to see how it works out

[jodge]

Im pretty sure I’ve done few K-lines with Smok as well.

dunno

it's from the support

Peugeot/Citroen 2001-2006 SIEMENS (connect the CAN H and CAN L pins to the connector of the controller, see the photos in the "MANUAL" tab)

The TDB using the same stuff

[ghostrider72]

dunno

it's from the support


The TDB using the same stuff

Or just buy newer multiplexer.

[p1et]

Lonsdor (type 4)

[Weasel3]

only when it's siemens and you need to do the ecu connections too, bcose the CAN lines are missing from the OBD socket

Like this one ? Siemens BSI 9642825280. Wouldn't give me anything when I tried to read by OBD.