BMW FRM Module Lamp Error

[bidu20]

Hi,
I have a FRM Module with short cirquit error(40124) (50 times ignition on)

can someone reset this Dump?


BMW e91 MJ 2005
PL2 FRMFA
E9X-E8XCA-XE
SW: 52541
HW: 10
S: 6135 6961134-02
AW: 6961625
eeprom 95320
read with elnec

Thanks!

[teerak2uk]

some diagnostic tools can do this now

To reset use tool32:
*load FRM87.prg (for FRM1)
*execute job STATUS_LAMPEN_KURZSCHLUSS_COUNTER
this will show a result window, outputs with counter >=50 are blocked


To reset blocked output:
*execute job "_reset_kurzschluss_sperre" with as argument the hex value of the blocked output.
Use the Table Info window to find this value for the affected output.


The output will now function again and the corresponding light should work


or search google for Gini bmw program that works with Dcan cable

[Dunker]

I had a 2014 3 series convertible with counter value 0x23h the other week. Resetting value worked and light was back on. So that's 35 decimal. Has there been a change ?

[tomic19]

Hello, read MC9S12XEQ384 D FLASH, post dump here and I will repair and sent you EEPROM file what you need write again inside...

Regards

[joker01]

[QUOTE = tomic19; 3480846] Ciao, leggi MC9S12XEQ384 D FLASH, postdump qui e io riparerò e ti ho inviato il file EEPROM di cui hai bisogno di scrivere di nuovo dentro ...

Saluti [/ QUOTE]

question ... I have repeatedly reset with tool32 for the counters ...... but you can also reset by writing a new file eee ???

thanks

[teerak2uk]

[QUOTE = tomic19; 3480846] Ciao, leggi MC9S12XEQ384 D FLASH, postdump qui e io riparerò e ti ho inviato il file EEPROM di cui hai bisogno di scrivere di nuovo dentro ...

Saluti [/ QUOTE]

question ... I have repeatedly reset with tool32 for the counters ...... but you can also reset by writing a new file eee ???

thanks

Possibly but never tried to reset via eeprom

Try this

https://mega.nz/#F!adVz3A4K!yM699dfBLgGPQbqPAmN5dg

[joker01]

grazie!!!!
con questa riparazione via obd con k dcan o ripara il dflash letto da mcu ???



opssss I have read your post above ......it is done by obd ....

[bidu20]

Thank you for your answers. I ordered the Tool32. If I have time, I read the Eeprom again after the reset to compare.

[teerak2uk]

Tool32 is free SW you just need the cable to use that or Gini sw

[tomic19]

I work with XPROG... Read DFlash, reset EEPROM inside, and write again yust EEPROM, worked 50 times by now, never problem after that...