Creation and duplication SDcard for Kess/Ktag/Trasdata

**Digital Under** · 20th January, 2019, 06:40 PM

No need read CID, no need use linux, no need use any program

-Erase new microSD
-Put microSD into Kess or Ktag, connect to computer and start Ksuite
-Create image in hex-editor and post here

**Mario6** · 20th January, 2019, 10:29 PM

Digital Under

Hi. I have a damaged SD card in Kess v2 5017 with a green PCB. I also have a second Kess with a red PCB. Kess with green PCB works with SD card from red. What should I provide you to fix this with green PCB. I have a new SD card. Do you need an SD card image opened by Hexeditor?

**Digital Under** · 20th January, 2019, 10:53 PM

clear new sd card,
inser in kess,
connect to pc and run ksuite,
create image from microsd in hex-editor and post here

**Mario6** · 21st January, 2019, 12:51 PM

Digital Under

Hi. I did as you advised me:
- I formatted a new card,
- I put the SD to Kess,
- I started the software kess 2.23,
- I created a picture of the card (my second kess) in the hex editor.
After a moment Kess came to life.
However, the protocols do not work. I can not put the SD card image because it is too big.

EDIT

Already repaired.
Thanks.Digital Under

**Digital Under** · 21st January, 2019, 02:13 PM

Originally Posted by Mario6

Digital Under

Hi. I did as you advised me:
- I formatted a new card,
- I put the SD to Kess,
- I started the software kess 2.23,
- I created a picture of the card (my second kess) in the hex editor.
After a moment Kess came to life.
However, the protocols do not work. I can not put the SD card image because it is too big.

EDIT

Already repaired.
Thanks.

read first post:

[COLOR=inherit !important]
[/COLOR]