Flashing Polo 6R 1,2 ECU from 60HP to 70HP

[1 6 D]

Hi,


Yesterday I tried to flash with ODIS-E ECU 03E90619M 8949 from Polo 6R 1,2 CGPB 60HP to 03E906019B 8951/9878 Polo 6R 1,2 CGPA 70HP but ODIS-E 5.0.14 with turned off control of files for UDS:
"In the selected flash container, no valid flash session could be determined fir the current control unit."


After that I selected FL_03e906019M__9877.frf and everything was ok, full flashing goes without issue. Is there some other control which should be turned off to flash ECU for more powered version?




I want to do thing like people make with VW UP! CHYA which are flashed to CHYB and make 75HP version from 60HP, maybe I should use VCP for this?

[paulamerica]

Hello, I am trying to flash with ODIS-E 4H0920920G which is dash on the 13 Audi A8, and I cannot find a flash container for this part anywhere. If you have one, would you please share. Thank you

[trivilin8]

Hi,


Yesterday I tried to flash with ODIS-E ECU 03E90619M 8949 from Polo 6R 1,2 CGPB 60HP to 03E906019B 8951/9878 Polo 6R 1,2 CGPA 70HP but ODIS-E 5.0.14 with turned off control of files for UDS:
"In the selected flash container, no valid flash session could be determined fir the current control unit."


After that I selected FL_03e906019M__9877.frf and everything was ok, full flashing goes without issue. Is there some other control which should be turned off to flash ECU for more powered version?




I want to do thing like people make with VW UP! CHYA which are flashed to CHYB and make 75HP version from 60HP, maybe I should use VCP for this?

Hello, did you find out how to flash that Ecu? I need to change software on a 03l 906 309 AC, from 03L 906 012 GM to 03L 906 012 BB. Happens the same thing, "In the selected flash container 'FL_03L906012BB_5935.frf' no valid flash session for the current control module 'Engine Control Module 1'could be detected.

Any help would be really appreciated. Thanks in advance