Here, try this....
Here, try this....
ziko (5th February, 2019)
Please if someone has tested, because costumer not live here and will go far from here, so must be good 100%
ziko (5th February, 2019)
100% ok. Pass PM.
ziko (5th February, 2019)
ziko (5th February, 2019)
Here you have 100% working solution.
Password via private Message
Did it many times on Mazda 6
Thanks to all who helped, I put "ecuworks" file and after flashin ecu DPF was blinking (in ecu no more DTC) so I did DPF regerenation with Delphi and after that DPF goes off and car has power again
Thanks again
Today dpf light comes again,and car not have power again
What next?
ziko (13th February, 2019)
Hm, sensors not disconnected,maybe thats problem in my case,but I readed other posts says sensors should be connected.
Will try as you say
Tnx
I put jenny123 and did all as you say,after 100m drive dpf flashing again,then I put kowal5 file (before with Delphi reset dpf,flash and reset oil) and till now is ok,will see next days. All sensors remain disconnected
Hello. After stopping the dpf with the swiftec the car has no power. Reset dpf and oil before and after flash. No effect. Can the problem be that the differential sensors are included? Both egt sensors show 700 ° C
PASS PLEASE ?
Bookmarks