VW PASSAT '13 immo info MED17.5.6 07906055CR

[dd1]

ok, you need the micro or eep or both????? remember i dont have the original ME, it has been swapped, the car starts ok but i have those 2 codes. CHECK ENGIE is on. i want them deleted. guide me friend..............

[DOUGLASDL]

[QUOTE = dd1; 3507187] ok, você precisa do micro ou eep ou ambos ????? lembre-se que eu não tenho o original ME, ele foi trocado, o carro começa ok, mas eu tenho esses 2 códigos. CHECK ENGIE está ativado. Eu quero que eles sejam apagados. guie-me amigo .............. [/ QUOTE]


reading micro and EPROM and confirms ECU image

[dd1]

hi, here are both

[dd1]

photo of the ecu

[nokwueze]

here is your file

[dd1]

hi and thank you NOKWUEZE, my issue is the fault codes, the car starts, someone had already immo it off for me. the only problem was that i had 2 fault codes in the engine control module. i needed DTC REMOVE. sorry about this brother

[DOUGLASDL]

record this file friend

[dd1]

hi, now is this the eeprom or micro??? sorry i am new to this. thank you

[DOUGLASDL]

micro file

[dd1]

[QUOTE = dd1; 3507168] muito obrigado pela sua ajuda. seu arquivo funcionou como um encanto. Posso lhe pedir um favor? alguém me ajudou com o outro vw jetta, é um me7.5, eu fiz um swap de módulo de controle do motor, o membro DK me ajudou com o problema IMMO, mas agora eu tenho o código de falha p0606 e p0030 também, esse código estava lá antes, então eu quero fazer um DTC REMOVE. Você pode me ajudar com isto? agradeço antecipadamente [/ QUOTE]


Yes friend sends a picture of the ecu and the original files

now the only thing i am stuck with is that the ABS / TRACTION light blinking on the cluster, fault code is for coding error. this happened right after cluster swapping took place. Since i have repaired the original cluster, i wonder why is it giving the error code? can you guys help me out with this issue???? the long coding is all 000000000000000. thank you in advance

[DOUGLASDL]

friend the error code disappeared with my edit in file

[dd1]

friend the error code disappeared with my edit in file

The abs fault code says "abs not coded" and the long coding is all 000000000000000000000. I need to recode the abs.

[DOUGLASDL]

LONG CODING

[dd1]

No, it is not your problem. Somehow the abs loses the long coding if you try another cluster. But I have repaired the original cluster now and need to decide abs also