SUZUKI Jimny 2008 Remote learning

[kalibrovich]

Hi guys

I cannot find any manula about remote programming for SUZUKI Jimny 2008

This procedure does not work
1) Confirm that the vehicle is the following conditions.
• All doors are closed.
• Ignition key is out of ignition switch.
• Driver side door is unlocked.
2) Disconnect negative (-) cable from battery.
3) After 30 seconds, perform the following procedure within 60
seconds.
a) Connect negative (-) cable to battery.
b) Operate driver side door knob switch from lock to unlock.
c) Push “LOCK” button on transmitter and confirm that are
operated from lock to unlock.
d) Push driver side door knob switch to lock position.
e) Push “LOCK” button on transmitter twice and confirm that
all doors are operated from unlock to lock. With this, code
registration is completed.


I also did try this one:
1. Switch ignition OFF and close all doors.

2. Open drivers door and switch ignition on

3. Switch ignition OFF

4. Press and release drivers door ajar switch 3 times

5. Switch ignition ON and then OFF

6. Press and hold each button of the remote in turn for 5 seconds each

7. Central locking should activate

8. Press remote control lock button

9. Maximum of 2 remotes possible

[Jimalex]

try this
b) Operate driver side door knob twise switch from lock to unlock.

[sleepyrz]

if you are using the electrical switch control for lock/unlock try moving the actual physical lock back and forth instead