Damaget BSI Peugeot 307

[r_parev]

Hello, I have a Peugeot 307 with a damaged BSI module, damaged by water. I read eeprom. Whether it is possible to write eeprom to another BSI and the car start or need the new BSI to train.


BSI is Valeo with MC912

Thanks

[yuka]

just write the eep in an identical bsi and it will work

[r_parev]

I write to another BSI but the car did not start. The two BSIs are not exactly the same, they are different revisions. Is this the problem or I need to write and flash

boot is Valeo with MC912

[yuka]

the bsi sw and hw must be the same
try to write the flash too, maybe it will work

[r_parev]

Ok, thanks

[drz]

You should check your bsi dump if there is vin and pin. If the dump is damaged, you will not start the car even with the new bsi with the same sw and hw. The best solution is to virgin bsi and configure with pps/lexia, you will need pin, you can find it in your bsi dump
(if it is good), or in engine ecu.

[gieteknysa]

post your dump here. If is ok read pin code and vin. In new(used) bsi put FF for all adress in eeprom (hc12) and reprogram with PP2000 like a new bsi.
its 10 minute job

[r_parev]

Please check my dump, maybe damaged.

[r_parev]

post your dump here. If is ok read pin code and vin. In new(used) bsi put FF for all adress in eeprom (hc12) and reprogram with PP2000 like a new bsi.
its 10 minute job

Can you post a little manuals? For guidance only.
1.
2.
3.
.................


for a man who did not do it.

Thanks.

[yuka]

Unfortunately, your dump is corrupt (that's why it did not start the car)
in your case:
1. you need to get pin code from the ecu eeprom
2. put a virgin dump in your bsi
3. program your bsi with pp2000 (see txt file)

[r_parev]

can i replace my bсi with this one?
This is my:
20190319_175752.jpg


This is new:
20190319_175749.jpg

[r_parev]

Please need pin code.
Peugeot 307
ECU Bosch EDC15C2 eeprom 95P08.

Thanks

[yuka]

pin code: JL6M