Suzuki Vitara 1,9DDIS read Bdm, flash changed, flash write. Not start. Key Coder OK

**Pyromaniak** · 25th March, 2019, 11:40 PM

checksum? have your ori and egr off? or eeprom bad (too much heat) (maybe not too much , but too long)

**WinWoj** · 26th March, 2019, 04:01 AM

Originally Posted by Pyromaniak

checksum? have your ori and egr off? or eeprom bad (too much heat) (maybe not too much , but too long)

No, I don't think so. Flash was checksumed, I'm sure that. And eeprom was read just after each test and always data was proper. Tomorrow I will check this new solution and report. Hope wiil start.

**TuningInside83** · 26th March, 2019, 12:24 PM

You have Try?

**ohkarol** · 26th March, 2019, 12:51 PM

push clutch before start engine

**Pyromaniak** · 26th March, 2019, 05:29 PM

Maybe checksum bad,for me BDM100 not calculate chks in iveco edc16c39 i read this like hyunday peugeot kia- maybe problem this. If i make chks in other program works. Can you send me off file? I oversure

if you want. OHcarol

**WinWoj** · 27th March, 2019, 11:35 AM

Originally Posted by TuningInside83

You have Try?

Yes, I already test your solution and without success - no start, P0606 x2 and f##cn shit.

Originally Posted by ohkarol

push clutch before start engine

Sure, I pressed clutch...

Originally Posted by Pyromaniak

Maybe checksum bad,for me BDM100 not calculate chks in iveco edc16c39 i read this like hyunday peugeot kia- maybe problem this. If i make chks in other program works. Can you send me off file? I oversure

if you want. OHcarol

I read galletto BDM, eep, micro and flash, I off flash with known software, count cks in winols and write it BDM. Not start. I writen 1st read flash & eeprom, still didn't start..
I worry about immo module, that it could be lost synchronization, during first cranking after BDM reflash battery completely died. Then used a brand new battery, but car still flooding P0606...