Hi guys,
What's the best transistor for OPEL X17DTL, 0 281 001 371, 0470 004 003 ?
I have this 2905, 3803, 44n25, 3705, 3205.
Thanks
Hi guys,
What's the best transistor for OPEL X17DTL, 0 281 001 371, 0470 004 003 ?
I have this 2905, 3803, 44n25, 3705, 3205.
Thanks
hello, i have a bmw 320d with vp44 pump. I replaced the transistor with IRLR 2905 PBF and now i get inpa error "Pump controll unit-EEPROM or ADC defect" . attached you have a picture of the way i soldered IRLR2905PBF. i used this method : .
What could be the problem? is this the correct transistor or shoul i use AUIRLR2905Z or IRLR3705Z ?
IMG_4480.jpgIMG_4484.jpg
We send the VP44 electronic and the people repair like this (picture)
20180111_221313.jpg
Hello tanks
20180224_161243.jpg
Anyone know if I need replace the transistor?
Or only soldering...
Replace transistor!
anjo008 (24th February, 2018)
IRLR 2905, IRLR 3110 or IRFZ44?
Only IRLR2905
Soldering with Sn60Pb40 is it good? Or I need special product?
Yes good...I can help you but write to me for private
anjo008 (1st March, 2018)
Anyone knows where this terminal goes ? Thx!
I damaged the pad where the drain connects to the circuit board, anyone know an alternative conection point?
PSG_board_pad.jpg
Does anyone know what the drain terminal connects to on the circuit board pictured? A flyback diode perhaps?
What about the other drain connection pin on the bottom right corner? Is this one of the solenoid leads? Which is the other solenoid lead?
Is there a schematic or circuit diagram available so I can better understand this circuit?
I cannot see any reason for the mosfet drain to be connected to the circuit board, other than for transient protection of the mosfet. Because I can't solder to the PCB drain pad, I propose to fit my own protection zener diodes as pictured. Any thoughts on this?
Solenoid_driver.jpg
Is there any information showing points where the solenoid wires connect to the PSG? I'd rather not interfere with the insulation on the solenoid wires to find out.
Last edited by dynasat; 23rd May, 2018 at 03:30 AM. Reason: added detail
Bookmarks