Rolls Royce Ghost

[tmohabir]

Hi guys I was able to removed the dash was'nt as difficult as I taught but I have one problem the system is the new bmw F1 i am using dp111 elpross i am able to read the cas but when to write I put 0 unit say complete ok, But when I read again the orignal value is there.Any suggestion . Thanks in advance

[matarelec]

post the 2 dumps of cas before and after correction and i will check it for you.

[dashradio]

He will be able to post the Elprosys dumps but they are encrypted

[coz1780]

whats the mask on cas chip

[54321]

Can blocker needed for Cas4

[sparkz02]

Don't input '0' try 1234 or whatever instead I've had this on a BMW before.

[smartymarti]

why would you write zero in ??????????

i always put 1234 and let it take to the amount required in cluster , its a xdp so you dont need a can blocker . im thinking the zero is your issue

[tmohabir]

Thanks guys I am going to try 1234 and let you know

[tmohabir]

1234 did not work iI guess I do have to used a can blocker

[tmohabir]

How do I get the files from DP3 to my labtop. Thanks

[rukartinatv]

on your mms card

[ALEXEI]

write desired value on cas module. as I know under 5000km you cant programm it. but sure will work without can blocker

[tmohabir]

Same problem it does not accept 5000 km it appears to write but the numbers does not change

[ALEXEI]

did you lift reset pin from mcu ?

[TULGEYWOODMAN]

Do you mean the numbers on the dash dont change or the numbers in the dp3?

You are doing the dash as well?