Engine control module incorrectly coded after immo delete

[chrissysnaith]

Just Installed my ecu edc15p+
For my Pd130 powered mk1 golf
firstly I backed up the flash and eeprom
then I flashed my old map onto it
Then I used edc15 calculator to deimmo the eeprom and wrote it using vag commander
The car starts and runs fine but vcds is saying my ecu is incorrectly coded
p1612-35-00
Any ideas could it be the old map?

[Stopro92]

P1612 - Engine Control Module Incorrectly Coded
n
Possible Symptoms
Driveability Issues Emissions worse


Other Fault Codes stored Possible Causes


-Engine Control Unit (ECU) incorrectly coded
-Incorrect Cruise Control Type enabled


Possible Solutions
-Check Engine Control Unit (ECU) coding
-Check Cruise Control Activatio

[chrissysnaith]

other faults are abs/air bag 18044,p1636 35-00 / 18057,p1649 35-00 missing message from controller (not an issue as the ecu is only there to run the engine )
17978 ,p1570 35-00 fuel pump relay open or short to ground again not an issue as im running one from the standard ce1 fusebox

[kiszka]

other faults are abs/air bag 18044,p1636 35-00 / 18057,p1649 35-00 missing message from controller (not an issue as the ecu is only there to run the engine )
17978 ,p1570 35-00 fuel pump relay open or short to ground again not an issue as im running one from the standard ce1 fusebox

does not work because they are two different ecu