Audi A6 3.0 v6 tdi 2007 with edc 16cp34 help checksumm error calculate for full bdm

[oltianmunga]

Got this morning this Audi A6 3.0 v6 tdi 2007 with edc 16cp34, car looks in limp mode but no check engine light only dtc are two inlet manifold runners bank1 and bank2 (normally when these are faulty check engine light stays on but the car runs good) anyway no signs of dpf soot acumulation did all resets with autel on dpf replacment ecu and diff press sensor all reseted still car stays in limp mode. while reading ecu as full bdm when saving file after saved ktag complains about checksumm of full bdm content, read separatelly mpc 564, flash, and eprom 95320 and for none of these files separatelly ktag doesnt complain for checksumm.error, put the flash file on ecm titanium and the file doesnt match with none of the families. is this a case of an previsious tuner messing up with files on ecu? should another original flash file or full bdm cure the problem? Looking for someone who can explain this inconvenient better,

can someone repair files for me please definatelly is checksumm error

[joker01]

your file is mod .... it seems to me dpf badly done.
the dtc table has been reset for this you have limp mode but no dtc spy ... later I see if I have a file ori bdm or I try to reconstruct it.
upload a file bdm ori and see what mistakes you have .....

[joker01]

try this file ori reconstructed

[oltianmunga]

thanks bro ill try and report

[oltianmunga]

this is only flash right?

[joker01]

yes only flash

[oltianmunga]

your file wont go in it says checksumm error

[joker01]

ktag is ori or clone???
have another tool for try????

[oltianmunga]

ok ill try that, someone else corrected flash checksum and it accepted no important dtc on diagnose but car wont start

[joker01]

I think it's not a file problem ....... on the file I made winols finds correct cks and ecm recognizes the driver .......
try reinstalling ksuite or using another version .....