Is there any fault codes in ecu?
could be turbo overboodt
good day, I have a problem, maybe you can help me, I'm from Germany and drive a mercedes ML 350 bluetec 2012,
( Bosch EDC17CP46 )
a tuner from here disabled me AGR DPF Bluetec off and now for months the car goes without performance and if i do kickdown in limp mode, but without codes.
when i turn it off and on it works great the whole Time, but when i switch it off again and turn it on again After Some Minutes the same problem with limp mode, turn it on and off and it works great again.
I have to start the car everywhere I am 2 times.
I disconnected the nox sensor under the car, and staked the Bluetec ECU in the trunk and of course made the DPF empty.
No one here can help me !
do you know why it can be?
Do i forgot something to disconnect ?
do I have to stake out something from the AGR?
Thank you very much !!!
Is there any fault codes in ecu?
could be turbo overboodt
Was Banned For Being Certifiably Insane and Stupid
yes, 3 days ago, the check engine lamp went on and it has indicated an error from the turbo. I do not know the exact code.
what can it be ?
Otherwise the error without lamp comes for 3 months.
I just have to turn the car off and on and it works great.
highway 200kmh no problem.
What can i do ? Please help me.
I Drive 3 months with this.
The DTC is „Boost pressure to low „
What can i do ?
Can anyone help me please
Bookmarks